36A, JALAN SONGKET INDAH 1/1,
TAMAN SONGKET INDAH,
08000 SUNGAI PETANI,
KEDAH, MALAYSIA.
+6011-37233461
+604-4250761
- Air Filter
- Aircond Bracket
- Aircond Cleaning Tools
- Aircond Coil Cleaner
- Aircond Filter
- Ball Valve
- Brazing / Welding / Soldering
- Capacitor
- Compressor
- Compressor / Refrigerator Oil
- Copper Pipe & Fittings
- Drainage Pump
- Electrical
- Filter Drier
- Hand Tools
- Hardware Items
- Household Cleaner
- Insulation
- Leak Test
- Manifold Gauge & Accessories
- Measuring Tools
- Mounting Rubber
- Others
- Parts / Components / Accessories
- PCB Board
- Pressure Washer
- PVC Pipe & Fittings
- Refrigerant
- Remote Control
- Solvent Cleaner
- Steam Cleaner
- Temperature Sensor
- Vacuum Pump
LE ZONE COOLER SDN BHD
36A, JALAN SONGKET INDAH 1/1,
TAMAN SONGKET INDAH,
08000 SUNGAI PETANI,
KEDAH, MALAYSIA.
36A, JALAN SONGKET INDAH 1/1,
TAMAN SONGKET INDAH,
08000 SUNGAI PETANI,
KEDAH, MALAYSIA.
Bitop Stop Leak 80g
| Previous | 2 / 3 | Next |
| Size | : | 80g |
|
Desciption |
: |
Bitop a/c stop leak will permanently stop leaks in condensers, connection hoses, evaporators, gaskets and o-rings in systems that can hold 5 inches of vacuum for 25 minutes. It is not recommended for systems that lose more than 1 pound of freon per day or leaking compressors. |
|
Direction |
: |
1. Turn silver twist valve all the way in a clockwise direction. 2. Shake can well. 3. Attach delivery system to can by screwing the red adapter to the top of the can puncturing the protective film. 4. Start car and turn a/c to max cooling. 5. Attach the quick coupler to the low side service port. 6. Once the quick coupler is attached check guage for accurate pressure reading. See table to compate outside temperature to sufficient pressure in system. If guage reading shows deficient pressure, slowly turn twist valve counter clockwise to release product. 7. Hold the can in a upright position and gently shake every 5 seconds while system is being charged. It should take 5 - 12 minutes for the can to be empty. 8. Check guage the throughout process to measure psi. Guage reading is only accurate when the compressor is cycing. DO NOT OVER CHARGE! If the system pressure is still low, add more R134A. |